Over time, the sedimentation of the pipe causes a significant decrease in the output water pressure and leads to affecting or even disrupting many people’s daily activities, and sometimes it may increase our need to a company which is active in the field of plumbing in Toronto. Therefore, getting to know the methods that cause pipe clogging and sedimentation can be very useful and effective in order to prevent them and also to provide a suitable solution to solve these problems.
Why does the pipe get sediment?
Some people may think that only sewer pipes get clogged; This is while in some cases we see clogging of hot and cold drinking water pipes. One of the main reasons for the clogging of hot and cold water pipes is the deposition of minerals and salts in the water on the inner walls of the pipe and scaling in the building’s plumbing system.
In fact, with the evaporation of water and the subsequent increase in the concentration of solutes, minerals and their sedimentation, pipe sedimentation occurs. During this process, the sediment layers increase until the passage of water through the pipes is not easily possible.
It is worth mentioning that if you see the first signs of cold or hot water blockage, we recommend that you immediately try to find the cause and solve it in order to avoid serious and more complex problems in construction facilities, such as the following:
- Causing rot and corrosion in the piping system
- Loss of efficiency of heating devices and engine room
- Increase in fuel consumption
- Holes and leaks in pipes
- Complete blockage of building branches
- Etc
Note: In general, the probability of precipitation of cold water pipes is much less than that of hot water pipes. Because the high temperature of the water accelerates the process of rotting and rusting of the piping system and ultimately sedimentation.
Most cold water pipe clogging is related to the blockage of the path by gravel, soil, etc., which resolves itself over time, but the factors that cause clogging and sediment in the hot water pipe are much wider, which we will mention below.
The first reason: the high hardness of the water in the area
Hard water includes minerals such as: calcium sulfate, magnesium sulfate, calcium carbonate and bicarbonate compounds. The higher the amount of mineral salts mentioned, the higher the degree of hardness of the water will be, and finally, more deposits will form in the pipe.
One of the most common signs to detect water hardness is slow foaming with detergents and especially soap. Consecutive clogging and sedimentation of the bathroom shower and dander or whitewash on the surface of the faucets and their connections, as well as the presence of sand and pebbles in the hot water outlet are also other signs of hardness and the presence of many salts.