In the previous section, we talked completely about clogging pipes with cement and so on. Today we want to tell you how to get rid of this type of blockage.

A variety of methods to remove clogged pipes

  • Use your hands to relieve clogging (for simple and trivial clogs such as rubbish entering the toilet siphon)
  • Use of solution or money for opening pipe (for non-hard clogs such as sink clogs, bath wells and floors)
  • Eliminate clogging with an opening pipe spring (for hard clogs such as rocks and dirt entering the floor or clogging the toilet well with waste)
  • Open the pipe with air compression device (for hard clogs such as clogging with rocks, dirt and debris)
  • Tube opener with waterjet device

As mentioned before, there are various methods for relieving congestion, and the above are just some of them. Methods that each are used for a specific blockage and are tailored to the type of blockage. Now, we come to the part where we talk about the middle ground. Eliminate clogging of pipes taken with cement, bitumen and other building materials, which is very common in buildings. This type of clogging can be considered the worst type of pipe clogging. Different types of methods to remove clogs with materials are:

Remove clogged pipes with cement or white cement

Those involved in the construction and repair of buildings are often affected by this problem and congestion. The cause of this blockage is the entry of cement or materials into the sewer pipes. Pipes such as toilet pipes, yard floors or roofs, etc., which are clogged by cement, mortar, lime and other materials. These materials cause severe clogging when they enter the pipe and remain inside the pipe forever. To remove these clogs, it is better to prevent cement from entering the pipe. Otherwise, you must remove the cement after rapid entry or empty some water inside the pipe so that the cements are washed quickly and come out of the pipe.

The same procedure is used for clogging white cement. But if the cement or white cement inside the pipe has hardened, there is no other choice but to replace the pipe. Because none of the pipe openers can remove this type of blockage, and if the pipe opener spring is used, the pipe may be damaged and the pipe may break completely. Therefore, in such cases, it is better to replace the pipe or siphon with the least damage.

Eliminate clogging with bitumen

This problem will arise if you intend to pave the building or you want to pave the yard. Bitumen is a very sticky and hard material that enters the pipe quickly causing a hard clog. But you should know that bitumen can be washed with gasoline or oil. So if bitumen was spilled into the pipe, you can pour oil or gasoline into the pipe to wash the bitumen with you. Due to the high price of gasoline, it is better to use oil so that you can empty a large amount of it into the pipe. If bitumen clogging is available to you, it is better to try to separate the bitumen from the pipe with a tall object such as wood. After finishing the work, you should pour some water so that the bitumen and oil are completely drained from the pipe.

In general, if your pipe gets such clogs, do not think about using the solution at all. Not only will the problem not be solved, but your problem will be doubled, and water may seep into other parts of the building by destroying the pipe. So in such cases, it is better to contact companies that specialize in plumbing in Toronto and Canada and get help from them.