If you have been with us this past week, you probably know that we have fully explained one of the ways to get rid of fungus and mold in the bathroom and bathroom. Today we want to tell you a few more ways so that you can do it without the help of an expert in the field of plumbing in Richmond Hill.
Ways to eliminate fungus and mold in the bathroom and sanitary ware
Removing fungus from bathroom and toilet tiles with borax
Borax or boric acid, which is also known by other names such as sodium boric acid, is considered one of the most powerful chemicals to eliminate fungus and mold in the bathroom and toilet. Mix 2 tablespoons of borax with half a cup of vinegar and 2 cups of hot water. Then do the following steps:
- Spray the resulting solution on all parts of the bathroom and toilet.
- Brush the mushrooms and molds to remove them from the surface.
- Then wash the tiles, wall and ceiling.
- Spray a small amount of the solution on them again to eliminate the effect of fungus and mold.
- After 15 minutes, clean the tiles again and allow the moisture to dry completely.
Note that the combination of vinegar and borax may cause respiratory allergies, so you must use gloves and a mask.
The unique effect of oxygenated water in eliminating fungus and mold in the bathroom
Another way to get rid of fungus and mold in the bathroom and toilet is to use hydrogen peroxide or hydrogen peroxide. Just spray a small amount of hydrogen peroxide on the surface of ceramic tiles and bathroom faucets. Wait about 15 minutes for this chemical to take effect on the fungi. Then brush on the surface to finally wash them with water.
A very important point is that, if the layers of mold are very thick, it is better to use other methods to eliminate them. Because hydrogen peroxide or hydrogen peroxide is mostly used as an antiseptic.
Eliminate fungus and mold in the bathroom and toilet with tea tree oil!
It can be safely said that one of the best and most powerful substances for cleaning fungus and mold from ceramic tiles is tea tree oil. Follow the steps below to use these disinfectants:
- Mix tea tree oil and water in equal proportions and spray on the desired surface
- Wait about 10 to 15 minutes for this solution to have its effect on the fungus and mold
- Brush on the desired surface to clean all dirt, fungus and mold.
Cleaning bathroom fungus with ammonia
Ammonia is a chemical disinfectant that has a very high power and, of course, its use requires high precision. Because combining it with other detergents and bleaches can bring many risks.
To wash the bathroom and toilet with ammonia, just spray a small amount of it on the desired surfaces. Then brush the surface to remove dirt and stains. Be careful not to mix it with Vitex or bleach to improve the cleaning power of ammonia.
Remove fungus and mold with bleach
Vitex or bleaching liquid is another suitable choice for cleaning and removing fungus and mold in the bathroom and toilet. Spray a small amount of Vitex on the surface of ceramic tiles, as well as the floor and ceiling, and bathroom and toilet faucets. Then clean the stain and dirt with a brush and finally wash the bathroom. Make sure that the supply system is turned on and the window and door are open, and use a mask and gloves.
Cleaning fungus and mold with baking soda
Mix one cup of baking soda with two spoons of liquid soap and a little water. Then spray the resulting mixture on the desired surface and wait a little. In the last step, brush and wash all parts of the bathroom and toilet that have been sprayed with this mixture.